NCERT Solutions for Class 10 Science Chapter 12: Magnetic Effects of Electric Current
Step-by-step solutions to every in-text and end-of-chapter question in NCERT Class 10 Science Chapter 12 (rationalised). Every direction answer is re-derived from the force law F = I L × B or the field of a current, and the oven's current is recomputed.
These are complete NCERT question answers for Class 10 Science Chapter 12, Magnetic Effects of Electric Current: all the intext questions and end-of-chapter exercise questions. Each one is an ideal answer written the way the CBSE marking scheme gives step marks: the rule or formula, the working, and the final answer stated clearly.
- Field lines run from N to S outside a magnet, are closed curves, crowd where the field is strong, and never cross.
- Right-hand thumb rule: thumb along the current, curled fingers give the field. A straight wire's field is concentric circles; inside a long solenoid it is uniform.
- Fleming's left-hand rule: forefinger along the field, middle finger along the current, thumb gives the force. The force is largest when current and field are perpendicular.
- For a moving charge, take the current along the motion of a positive charge and opposite to an electron's.
- Domestic circuits: live (red), neutral (black), earth (green); fuse and earthing for safety. Overloading when exceeds the rating.
In-text questions: magnetic field and field lines (after 12.1)
Section 12.1, Intext question 1
Tests: Explaining a compass needle as a small magnet in a field.
Show solution
- A compass needle is a small bar magnet. Near a bar magnet it is in that magnet's magnetic field.
- The field exerts forces on the needle's poles (like poles repel, unlike poles attract), which turn the needle so it lines up along the field line at that point.
In-text questions: field lines (section 12.2, after the right-hand thumb rule)
Section 12.2 (a), Intext question 1
Tests: Drawing the field pattern of a bar magnet.
Show solution
- Draw the magnet with N and S marked. Draw closed curves leaving the N pole and entering the S pole, arrows pointing from N to S outside the magnet.
- Inside the magnet the lines run from S to N, so each line is a closed loop. Draw the lines crowded near the poles (strong field) and spread out farther away; no two lines cross.
Section 12.2 (a), Intext question 2
Tests: Listing the properties of field lines.
Show solution
- Outside a magnet they go from the north pole to the south pole; inside, from south to north. They are closed curves.
- The tangent at any point gives the direction of the field there (the way a compass's north pole points).
- They are closer together where the field is stronger (near the poles).
- No two field lines intersect.
Section 12.2 (a), Intext question 3
Tests: Reasoning from the uniqueness of field direction.
Show solution
- At a point where two lines crossed, there would be two tangents, so the field would have two directions there.
- A compass needle placed there would have to point in two directions at once, which is impossible. So the field has one direction at each point and lines cannot intersect.
In-text questions: circular loop and solenoid (section 12.2)
Section 12.2 (b), Intext question 1
Tests: Applying the right-hand thumb rule to a circular loop.
Show solution
- Treat each small piece of the loop as a straight wire. Point the right thumb along the current (clockwise, seen from above); the curled fingers give the field.
- Inside the loop the fingers point down: the field goes into the table. Outside the loop they come up: the field comes out of the table.
- Seen from above, a clockwise current makes this face a south pole (field lines enter it).
Section 12.2 (b), Intext question 2
Tests: Representing a uniform field with field lines.
Show solution
- Draw parallel straight lines, equally spaced, all with arrows in the same direction.
- Equal spacing shows the same strength everywhere; parallel lines with the same arrow show the same direction everywhere.
Section 12.2 (b), Intext question 3
Tests: Knowing the field inside a long solenoid is uniform.
Show solution
- Inside a long current-carrying solenoid the field lines are parallel straight lines: the field is uniform, the same at all points.
In-text questions: force on a current-carrying conductor (after 12.3)
Section 12.3, Intext question 1
Tests: Seeing that a magnetic force changes direction of motion, not speed.
Show solution
- The force on a moving charge is perpendicular to both its velocity and the field, so it changes the direction of motion but not the speed.
- Velocity (a vector) changes because its direction changes; momentum changes with it. Mass and speed stay the same.
Section 12.3, Intext question 2
- (i)Current in rod AB is increased
- (ii)A stronger horse-shoe magnet is used
- (iii)Length of the rod AB is increased
Tests: Linking the force on a conductor to current, field and length.
Show solution
(i) Current in rod AB is increased
- The force on the rod is proportional to the current, so a larger current gives a larger force.
(ii) A stronger horse-shoe magnet is used
- The force is proportional to the strength of the field, so a stronger magnet gives a larger force.
(iii) Length of the rod AB is increased
- The force is proportional to the length of conductor in the field, so a longer rod (in the field) feels a larger force.
Section 12.3, Intext question 3
Tests: Applying Fleming's left-hand rule to a moving charge.
Show solution
- Positive charge moving west: the current is towards the west (middle finger).
- Force towards the north (thumb). With the left hand set so, the forefinger points upwards.
- Check: west × up = north.
In-text questions: domestic electric circuits (after 12.4)
Section 12.4, Intext question 1
Tests: Naming the fuse and earthing as safety measures.
Show solution
- Electric fuse (or MCB): it melts and breaks the circuit when the current becomes too large, from overloading or a short circuit.
- Earthing: the metal body of an appliance is connected to the earth wire, so a leakage current goes to earth and the user does not get a severe shock.
Section 12.4, Intext question 2
Tests: Using I = P/V to spot overloading.
Show solution
- W, V.
- A
- This is more than the 5 A rating, so the circuit is overloaded: the fuse melts (or the MCB trips) and cuts off the supply. Without a fuse the wires would overheat and could cause a fire.
Section 12.4, Intext question 3
Tests: Stating how to avoid overloading.
Show solution
- Do not connect too many appliances to a single socket or circuit at the same time.
- Use high-power appliances (heaters, ovens, geysers) on the separate 15 A power circuit, and fit a fuse of the correct rating in each circuit.
Exercises (end of chapter)
Chapter 12 exercise, Question 1
Tests: Knowing the field pattern around a straight current.
Show solution
- Around a straight current-carrying wire, the field lines are concentric circles in planes perpendicular to the wire, centred on it (right-hand thumb rule).
Chapter 12 exercise, Question 2
Tests: Linking a short circuit to a sudden rise in current.
Show solution
- When the live and neutral wires touch, the resistance becomes very small, so becomes very large.
Chapter 12 exercise, Question 3
- (a)The field at the centre of a long circular coil carrying current will be parallel straight lines.
- (b)A wire with a green insulation is usually the live wire of an electric supply.
Tests: Checking facts about a coil's field and wiring colours.
Show solution
(a) The field at the centre of a long circular coil carrying current will be parallel straight lines.
- A long circular coil is a solenoid. Inside it, the field is uniform: parallel straight lines.
(b) A wire with a green insulation is usually the live wire of an electric supply.
- Green insulation marks the earth wire. The live wire has red (or brown) insulation; the neutral, black (or blue).
Chapter 12 exercise, Question 4
Tests: Naming ways to produce a magnetic field.
Show solution
- 1. A permanent magnet, such as a bar magnet or a horse-shoe magnet.
- 2. An electric current: a current-carrying straight wire, loop or solenoid (an electromagnet if it has a soft iron core).
Chapter 12 exercise, Question 5
Tests: Comparing a solenoid with a bar magnet and finding its poles.
Show solution
- The field pattern of a current-carrying solenoid is like that of a bar magnet: one end acts as a north pole and the other as a south pole, and inside the field is uniform.
- Yes. Bring the north pole of a bar magnet near one end of the solenoid. If it is repelled, that end is the north pole; if attracted, it is the south pole (confirm with the other end, which should repel the bar magnet's south pole).
Chapter 12 exercise, Question 6
Tests: Knowing the force is largest when current and field are perpendicular.
Show solution
- The force is largest when the direction of the current is perpendicular to the magnetic field (and zero when they are parallel).
Chapter 12 exercise, Question 7
Tests: Applying Fleming's left-hand rule to an electron beam.
Show solution
- The electrons move from the back wall to the front wall, so the current is from the front wall towards the back wall (middle finger).
- The force is to your right (thumb). With the left hand set so, the forefinger points vertically downwards.
Chapter 12 exercise, Question 8
- (i)magnetic field produced around a straight conductor-carrying current,
- (ii)force experienced by a current-carrying straight conductor placed in a magnetic field which is perpendicular to it.
Tests: Stating the right-hand thumb rule and Fleming's left-hand rule.
Show solution
(i) magnetic field produced around a straight conductor-carrying current,
- Right-hand thumb rule: hold the conductor in the right hand with the thumb pointing along the current. The fingers wrapped around it give the direction of the magnetic field lines.
(ii) force experienced by a current-carrying straight conductor placed in a magnetic field which is perpendicular to it.
- Fleming's left-hand rule: stretch the thumb, forefinger and middle finger of the left hand mutually perpendicular. If the forefinger points along the field and the middle finger along the current, the thumb gives the direction of the force (motion) on the conductor.
Chapter 12 exercise, Question 9
Tests: Explaining a short circuit.
Show solution
- A short circuit occurs when the live wire and the neutral wire come into direct contact, for example when insulation is damaged or an appliance is faulty.
- The resistance of the circuit then becomes very small, so the current () rises abruptly, heating the wires and possibly causing a fire.
Chapter 12 exercise, Question 10
Tests: Explaining earthing as a safety measure.
Show solution
- Function: the earth wire (green insulation) connects the metal body of an appliance to a metal plate buried deep in the earth, giving a low-resistance path for any leakage current.
- If the live wire touches the metal body, the current flows to earth instead of through the user, and the body stays at the earth's potential. So the user does not get a severe electric shock.
Chapter notes
Questions are from the NCERT Class 10 Science textbook, Chapter 12; word problems are paraphrased with every number kept.
Questions from the NCERT textbook are reproduced for educational and review purposes only, under fair dealing. All copyrights in the questions belong to NCERT. Solutions and explanations provided here are original works by Your Abhyaasika, generated with AI, and may contain mistakes. Your Abhyaasika is not affiliated with CBSE or NCERT.